Yes it is possible.
Contact SCANCAD in Morrison, CO: 1-303-697-8888.
They can give you a quote on such a job.

Regards, Ahne Oosterhof

-----Original Message-----
From:   TechNet [mailto:[log in to unmask]] On Behalf Of [log in to unmask]
Sent:   Monday, March 20, 2000 23:56 PM
To:     [log in to unmask]
Subject:        [TN] Question: Film to Gerber - how?

Hi Ya'll,

I got again this old problem. I have the films, but need the Gerberdata. Is
there a way to do it without making a complete new design?

Regards

Jens Behrens

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################