Technetters,

Need some help from all the Technetters out there, on specific ways of
reporting data in defect management systems. We are implementing the SAP
"QM" module and this issue has been raised and I need to address it for the
implementation team. To what level of detail do you(technetters) put
reference designations for Chassis level assembly. For example, a screw is
not tightened to specification. How are you recording that defect in your
tracking systems? Just stating a piece of hardware is loose or are you going
to the detail to identify every piece of hardware noted on a BOM and
assigning a unique identifier or  "WHAT?"  All experiences and suggestions
will be appreciated. Please respond either personally or through Technet.

Thanks
Carl Barnes
Quality Analyst
Varian Electronics Manufacturing

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################