Just testin' ; yo know, thinkin' of that moola mess, mixin', kneadin';
poor Doug with polymerofluxive dough onder 603's (next Dilbert's episode);
just ready to rename .
Poet hey ?; reminds me , yo know Mr. Bean used to be electronic eng. by
trade ?
So true feelin' ; sorry mate, need a holiday....o&o paul
-----Original Message-----
From: [log in to unmask] [mailto:[log in to unmask]]
Sent: Wednesday, 16 February 2000 13:13
To: [log in to unmask]; [log in to unmask]
Subject: Re: [TN] Cure and Reflow
In a message dated 02/15/2000 5:41:07 PM Central Standard Time,
[log in to unmask] writes:
> "BAD idea for just the reasons Paul talks about"
>
> Steve , no need to insult Dough by callin him Paul .
My mistake, apologize Doug, but it was a slip on the ol'
keyboard...actually,
I don't think it's really a bad insult Paul, I consider both you and Doug
pretty much "Gurus" in your own rights (am I kissing-up enough? hehehe...)
P.S. I didn't call Doug; "Dough"... Dough is something that you make bread
with, but then again, maybe that's something that Doug has a lot of?! Bread
that is, as in moola, coin, bucks, etc.. But working in this business I
doubt
it...
> Otherwise, just to make you true ,
> Paul talks same as you two,
> all sticks (without glue),
> check the archives (too),
Writing that paragraph,
did you know you were a poet,
but didn't know it?
I DID IT TOO!
HA!HA!HA!
(Gawd, this is getting weird!)
Seriously, I know there's a lot of people out there that's doing this
process, but as we did when doing this simultaneous glue cure / reflow
process at my past employer, the focus was JUST on the solder joint, not
"the
mess underneath" as both Doug and Paul have alluded to...
It IS something to take into consideration, and should generate some very
legitimate and valid concerns...it wound-up costing us instead of saving us
rework costs like we thought back then...
-Steve Gregory-
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
