An Engineer just came to me and ask if I could find out what the flatness spec
would be called out in a Aluminum casting that supports a printed circuit board.
Any takers on this or suggestion where to start. We call out a flatness (Bow &
Twist spec per IPC-D-275) but I'm not sure if this is sufficient for casting
operations.
Steve Collins
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################