Hi Technetters,
Does anyone have any experience they could pass on
regarding the automatic dispensing of UV cure epoxy.
I am trying to dispense onto a substrate and then
whilst holding the component being bonded in place
with the bond head cure the material. My only problem
is that the dispense head is attached to the bond head
and I am worried about the UV material curing in and
around the needle.
Thanks
Bob Mewes
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################