Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 25 Feb 2000 13:53:11 +0200 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Brent
IMHO, brass in contact with a solder wave is a big no-no. Just 0,001% of
Zn in your solder can render it fit for the scrap heap. As others have
said, a Ni overplate will stop the zinc leaching into the solder, but Ni
is not easy to solder unless you use a fairly active
hydrochloride-activated flux. And remember that if the pin is a push-fit
in the hole, the Ni may be abraded off, leaving the brass naked. My
suggestion: use some form of hot-tinned bronze rather than brass.
Brian
gelon wrote:
> Has anyone ever tried to flow solder brass pins before? We are
> attempting to do this and not having much luck. If anyone has done
> this before and has some suggestions that might help I would
> appreciate it thanksBrent Green
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|