Lately I have been seeing failure analysis that indicates the failures
were caused by trying to take a through hole component and bending
the leads up and around or under the component body to make it
a surface mount component. In one case a crystal seal was broken
and another the bends were just too "springy".
Is there a set of suggestions as to how and when and IF this can be
done to a through hole component?
Susan Mansilla
Technical Director
Robisan Lab
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################