As a contract manufacturer, we recently have asked if we had any
problems when assembling PCB's that have been constructed using
"GTek".
Does anyone have any assembly experience regarding "localized heat" or
using "press fit connectors" on this material?
Is there any other properties that I should be aware of when I am
assembling components on these boards? (Board bowing, hydroscopic
properties that limit the board from going through the wash)
Thank you for any input
Rob Green
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################