Hello Fellow TechNeters,

We build Class 3 hardware per J-STD-001 and stabilize every through hole
component prior to wave solder. I believe this is a hold over from Mil.
Spec. days and wondering if anyone else is doing this. The requirement per
J-STD-001 is to "process in a manner that precludes movement that
detrimentally affects formation of acceptable solder connections."

To stabilize or not to stabilize, that is the question.

Thank you,

Ken Bloomquist
Sr. Principal Process Engineer
PRIMEX Aerospace Company
P.O. Box 97009
Redmond, WA 98073-9709
http://www.primextech.com

Ph:   425-885-5000
FAX: 425-882-5786
[log in to unmask]

Northcon/2000, Chairman of the Board
http://www.northcon.org

Electronics Manufacturers Association (EMA), President
http://www.ema-wa.org

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################