Date sent:              Tue, 18 Jan 2000 17:03:56 -0500
From:                   Ron Ryan <[log in to unmask]>
Subject:                [DC] No artwork
To:                     [log in to unmask]
Send reply to:          "DesignerCouncil E-Mail Forum." <[log in to unmask]>,
        Ron Ryan <[log in to unmask]>
Hi Ron,

We have had the  same condition several times. Our CAD system is
OrCad, and using it, and the existing board as a guide, we were
able to re-create the database for new production boards. It is not all
that difficult with the board as a guide, and if changes or
improvements are required, these can be accomplished at the same
time.

Bob Gorge
Fermi National Accelerator Laboratory



We have a need to recreate printed circuit board artwork from an existing
double sided board that was manufactured from hand taped artwork.
Unfortunately all we have is the board. Our Cad system is PADS and
AutoCad.  Any suggestions?? There are around 100 equivalent ICs.

Thanks

 >< >< >< >< >< >< >< >< >< ><
        Ronald J. Ryan
Brookhaven National Laboratory
Instrumentation Division
Building 535B
Upton, New York 11973
        voice......(516) 344-6068
        [log in to unmask]
 >< >< >< >< >< >< >< >< >< ><