越是细的引脚,越是要注意成型工装的加工。从你图上看应该是工装弯脚处处理得不够圆滑。
Best Regards,
James Liu 刘春光
Director, Industry Programs 工业项目总监
IPC China
上海市长宁区延安西路1088号2303室
Suite 2303,#1088 West Yan'an Rd., Changning, Shanghai 200052 PRC
Tel: +86 21 5497 3435
Fax: +86 21 5497 3437
MP: +86 136 0133 3491
[log in to unmask]<mailto:[log in to unmask]>
www.ipc.org.cn<http://www.ipc.org.cn>
发件人: TGAsia [mailto:[log in to unmask]] 代表 Nancy Deng
发送时间: 2010年6月10日 17:35
收件人: Listserv TGAsia
主题: [TGAsia] 元件引脚的损伤标准
Hello, all:
在IPC-A-610 7.1.2.3 引脚成形时,元件引脚的损伤超过引脚直径的10%,为缺陷1,2,3级。
对于细引脚元件,特别是直径小于0.8mm 的元件,在成形的过程,不可避免的损伤的直径一般为10-20%,请参看下图,不知各位在损伤的标准是否做过让步?让步的标准是什么?
[cid:[log in to unmask]]
谢谢不吝赐教!
Best regards and thanks
Nancy Deng
_
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________