Menisque --> meniscus (sing.),  menisci (pl.) 

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Hfjord
Sent: Friday, October 12, 2007 2:15 PM
To: [log in to unmask]
Subject: [TN] Mouuuuh!

Ah! You couldn't resist open this mail! Good. I need curious and
creative people here. Imagine this:
Step 1: three FR4 boards 1x5 inches, just copper on both sides.
Step 2: another three boards exactly same Step 3: machine three slots
halfway in the first board Step 4: machine three slots halfway in the
second board Step 5: slide the boards into each other so that you get a
'honeycomb'
Step 6: solder all the corners, there will be 36 corners.
Question: how would you do that? 
Screen print along edges and solder mask to enhance solder to wet in the
90 degree corners?
Use IR oven or VP?
How do you avoid 'hanging' solder?
How do you get a nice, even and conformal solder menisque (how on earth
do you spell that?)

Inge

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To
unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET
Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the
posts: send e-mail to [log in to unmask]: SET Technet Digest Search the
archives of previous posts at: http://listserv.ipc.org/archives Please
visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for
additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------