There is another item to consider in determining the cause of adhesion
problems. You might want to investigate the need to use a primer prior
to applying the conformal coating. Again, as mentioned by Mr. Fisher
below, contact the technical people at the coating manufacturer for
recommendations.
Art Perez
Woodward Governor Co.
----------
From: [log in to unmask]
To: [log in to unmask]
Subject: Re: ASSY: CONFORMAL COATING ADHESION
Date: Wednesday, March 19, 1997 6:50AM
It is possible that the conformal coating you want to use is not
compatible
with the particular solder mask on the boards you have. To check for
this,
may ZI suggest:
1. Take a small section of a board and clean it thoroughly with an
alkaline
cleaner (Joy dishwasher miracle can work), rinse, clean with isopropyl
alchohol, rinse and dry thoroughly.
2. Dip the cleaned board sample in the conformal coating to be tested
and
dry/cure according to the manufacturers spec sheet.
3. Look for a smooth, continuous coating of the conformal coating over
the
entire surface of the sample board and conduct a cross hatch adhesion
test,
For this, take a razor blade, cut 6 parrallel lines about 1/8" apart,
cut 6
more parallel lines (perpendicular to the 1st 6 lines) about 1/8" apart
and
then apply a strip of 1" Scotch transparent tape to the grid pattern you
have
made. Pull the tape up sharply and look for any lifting of the conformal
coating.
4. If everything looks okay, you can say that the conformal coating is
compatible with the solder mask. If there is adhesion loss, then the
conformal coating is not compatible and either the conformal coating or
the
solder mask must be changed.
Since most conformal coating manufacturers offer many different types
(acrylics, epoxies, urethanes, silicones, etc.) of conformal coatings
and
different formulas in each type range, I.m sure that if you contact the
specific conformal coating manufacturer, they would be able to give you
the
right direction to go.
Hope this information helps.
Larry Fisher
Dexter Electronic Materials
[log in to unmask]
************************************************************************
***
* TechNet mail list is provided as a service by IPC using SmartList
v3.05 *
************************************************************************
***
* To subscribe/unsubscribe send a message <to: [log in to unmask]>
*
* with <subject: subscribe/unsubscribe> and no text in the body.
*
************************************************************************
***
* If you are having a problem with the IPC TechNet forum please contact
*
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]
*
************************************************************************
***
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
