Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 15 May 1998 07:51:13 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
A word of caution: Holes will normally plate shut closer to the surfaces,
leaving a barrel shaped hole with trapped plating solution.
----------
> From: [log in to unmask]
> To: [log in to unmask]
> Subject: [TN] Copper Plugging Vias
> Date: Tuesday, May 12, 1998 3:47 PM
>
> Address,
>
> How many suppliers are copper plugging .008 finish vias, provided
the
> surface finish is OSP. Provide your answer(s) on finished board
> thicknesses of .062 and .028, std tolerances. If so, what
percentage,
> nominal, are you able to plug shut. Through cross-sectioning do you
> have the following conditions.
>
> From my past experience the plugging of vias is not feasible using
an
> electroless and electrolytic plating combination process.
> Cross-sectioning would later show a dog-bone effect. Does this
still
> hold true today.
>
> Thanks,
>
> John Gulley
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV
1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
> For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
> ################################################################
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|