---------- Forwarded message ----------
Date: Tue, 16 Jul 1996 17:47:11 -0500
From: Fred Pescitelli <[log in to unmask]>
To: [log in to unmask]
Cc: [log in to unmask]
Subject: Thin laminates

All, 
Has anyone any experience using .010 FR4 for double sided boards? Also I
need to place 4- 0.025 dia plated thru holes centered on the edge of the
board. The board will be have to be panelized, so it will either be
V-Scored, punched, or routed (right through 1/2 of the dia of the holes. I
have been told that some companies are doing this, but I am sceptical.  I
can't believe there will be any plating left. Has anyone done this, or do
you have any thoughts on the matter?

Regards
Fred Pescitelli
Phoenix Designs
1285 Turner Rd.
Lilburn, GA   30247
[log in to unmask]
770-923-3465

****************************************************************************
* The mail list is provided as a service by IPC using SmartList v3.05      *
**************************************************************************** 
* To unsubscribe from this list at any time, send a message to:            *
* [log in to unmask] with <subject: unsubscribe> and no text. *
****************************************************************************


***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************