Good Morning

Requirements question.

A customer requests that designs "meet the requirements of
ANSI-J-STD-001A-1995 for preparation and soldering of electrical
connections."  [Assume Class 2.]

Question:  In the above statement, are there any PWB Fab requirements,
design or acceptance ?

What I found:  In J-001 there are references to IPC-D-275 and IPC-RB-276.
References I found are: inside front cover, 2.1.2, 2.2.1, 3.4.1, and 5.0.

Point of confusion:  My gut tells me there's gotta be a call out in here
somewhere, but these references do not look like requirements to me, they
look like general information.

Thanks for you help
George Franck


***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************