Gary Peterson asked:

>Can anyone point me to a drawing for the thermal path wedgelocks that are
>used on conduction cooled VME boards?  They must be part of the card
>cage assembly.  I'm told there is a VME spec. that describes the
>whole assy.

We make a lot of VMEbus products, but none with these "wedgelocks". The
VMEbus spec is ANSI/IEEE Std 1014. My 1987 copy does not seem to show
these.

Most of the Eurocard hardware is made by Schroff, Scanbe, or Mupac. You
might also try Dawn VME Products.

Another source would be VITA (VMEbus Int'l Trade Association)

John Rynearson                       PH: 602-951-8866
Technical Director, VITA             FX: 602-951-0720
7825 E. Gelding Drive, Suite 104     email: [log in to unmask]
Scottsdale, AZ 85260                 http://www.vita.com/


good luck,

Jerry Cupples
Interphase Corporation
Dallas, TX USA
http://www.iphase.com/