Hi Technet,

For the design of some double sided reflow boards I'm trying to anticipate on using a programmable point soldering machine in the future. This is for the few leaded components that are still on these boards. 
Could anybody give me some insight on how much free area is needed around the leads ? Are there other special design rules that we should use ?

Daan Terstegge
Unclassified mail

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################