I have been having problems with excessive dross build-up in our wave
solder machine.
We are considering adding marbles to the solder pot. I_ve heard
conflicting advice on whether or not this is a good idea. I have heard
that it may keep the dross down, but it may also increase the
contamination levels. Does a dross layer over the marbles protect the
solder from contamination? DOES ANYONE HAVE ANY ADVICE ABOUT DROSS &
MARBLES?
-Art Pauly
*******************************************
Art Pauly ([log in to unmask])
Manufacturing Process Engineer
Kistler Instrument Corporation, USA
Phone: (716)691-5100 Fax: (716)691-5226
World Wide Web http://www.kistler.com
*******************************************
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################