Is there an industry standard or rule of thumb when it comes to drilling
accuracy and repeatability?  How close should 0.015 inch drilled holes be to
where they want to be?  How consistent should the drilling be across a
board?  Should all the outer layer lands get hit at about the same spot as
one another?  Any enlightenment on this topic would be appreciated.

Thanks,
Gregg
_________________________________________________________
Gregg Klawson                        tel: +1.508.880.1822
GTE Government Systems Corp          fax: +1.508.880.4891
Taunton, Massachusetts USA         email:  [log in to unmask]

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************