Folks,

I was asked this morning if anyone out there utilized any type of protective board cover while rework was being performed to their assemblies.  Their notion was that using such might prevent an accidental solder splash or ball from dropping into an area and it going undiscovered.

Does such an animal exist?

I know it would be awkward and cumbersome, and would be met with a lot of resistance from people who actually perform the operation...

Thanks for your help!

Leland



________________________________

“Confidentiality Notice:
This transmission (including any attachments) may contain confidential information belonging to the sender and is intended only for the use of the party or entity to which it is addressed. If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution, retention or the taking of action in reliance on the contents of this transmission is strictly prohibited. If you have received this transmission in error, please immediately notify the sender and erase all information and attachments.”

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________