IPC-TM-650 2.4.25
eric
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez
Sent: Wednesday, November 28, 2012 7:30 AM
To: [log in to unmask]
Subject: Re: [TN] Delta Tg on a Pb-free board.
Board guru,
Is there a test method, IPC Standard, for testing how well a laminate has been cured, IS415.
"X"
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Steve Zweig
Sent: Tuesday, November 27, 2012 4:11 PM
To: [log in to unmask]
Subject: Re: [TN] Delta Tg on a Pb-free board.
On Nov 27, 2012, at 4:46 PM, "Vladimir Igoshev. PhD" <[log in to unmask]> wrote:
> Hello board gurus,
>
> We ran a DSC test on a Pb-free PWB and found that Tg1 was around 172C,
> while the second heating produced Tg at about 185C. Below is a reply
> from the board vendor, stating that there is no such a thing as
> undercured laminate for that specific type of material.
>
> I'd greatly appreciate any constructive comments.
>
> "...That type of delta Tg would only apply to dicy materials when Tg1 and Tg2 are less than the advertised Tg of the material.
> EM-827 is a high Tg, filled phenolic and as such for these type phenolics, there is no delta Tg that signifies undercure.
> With filled phenolics like this both the Tg1 and Tg2 would be under the advertised Tg to be undercure and this is not the case.
> As you cure more and more these type phenolics both Tg1 and Tg2 move
> to higher and higher values and the delta Tg remains about the same".
>
>
> --
> Best regards,
>
> Vladimir Igoshev. PhD mailto:[log in to unmask]
>
> SENTEC Testing Laboratory Inc.
> 11 Canadian Road, Unit 7.
> Scarborough, ON M1R 5G1
> Tel: (416) 899-1882
> Fax: (905) 882-8812
> www.sentec.ca
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or
> [log in to unmask]
> ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
**********************
** LEGAL DISCLAIMER **
**********************
This E-mail message and any attachments may contain
legally privileged, confidential or proprietary
information. If you are not the intended recipient(s),
or the employee or agent responsible for delivery of
this message to the intended recipient(s), you are
hereby notified that any dissemination, distribution
or copying of this E-mail message is strictly
prohibited. If you have received this message in
error, please immediately notify the sender and
delete this E-mail message from your computer.
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|