Do check with your design staff, a cko6 was never intended to be mounted 
.060 off the board.  If your system goes thru any moderate to heavy vibration,
you will be needing to bond them to the board.

	Conformal coat to a reasonably sized base would probably be sufficent
	(molded standoff not bead or sleeving)

	The main reason to standoff the component is to inspect the topside
solderjoint.  Putting on a spacer that hides/inhibits this may not be acceptable 
to your NASA inspector.

Bill Gaines
AeroJet (for $) 1100 Hollyvale, Azusa, Calif. 91702-0298
IEPS -> ISHM 
IHPVA   (for speed)   P.O. Box 727 Elgin, Il 60121-0727
SCCA    (for trophys) Solo II (818-988-RACE)
o-`oo+ o`-oo+
(my two trikes)
IHPVA # 453

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************