Subject: | |
From: | |
Date: | Tue, 16 Apr 96 10:42:25 EST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Where does one get a copy of PRF 31032 and who's spec is it?
Jim Spendow
Fax 616-241-8686
Ph 616-241-8413
______________________________ Reply Separator _________________________________
Subject: Re: FAB-etchback
Author: [log in to unmask] at SMTPpost1
Date: 4/16/96 9:50 AM
PRF 31032, which is the spec intended to replace MIL P 55110 has the same
requirements in it for etchback, which are .0002 - .003" when specified by the
master drawing. If no etchback is specified, than a negative etchback of
.0005 is allowable.
--------------------------------------
Date: 4/15/96 10:23 AM
To: LISA GREENLEAF
From: Lyle Andersen
Can anyone inform me of the current status of the military requirement re:
etchback? A potential customer's blueprint references 55110D and
specifically calls out for etchback on type 3 boards (multilayer). However,
the board will have a commercial application and, as is common with
blueprint notes, this may be of the "boilerplate" variety. They may be
satisfied with desmear with a little education and persuasion. Thanks to
any who respond.
Lyle Anderson
Electrostar-Utah Division (formerly Lundahl Astro Circuits
Phone 801-753-4700 ext. 3040
|
|
|