Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 7 May 1998 13:56:11 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We seem to have an issue with tents breaking on large
holes ( .180 to .250 dia. ) as well as slots, typically .118 x .250.
No matter whose film we have tried, the tents break. It is not always
every panel, nor every lot. We have an idea that it may be being
caused by the developer. Has anyone out there wrestled with this
problem, and if so how was it resolved. To switch to secondary drill
would just impact that departments output Any help will be deeply
appreciated.
Ernie Smith
Electropac Co. Inc.
e-mail to [log in to unmask]
or on the technet
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|