Subject: | |
From: | |
Date: | Wed, 2 Oct 1996 15:21:11 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Brittle copper on the Surface:
As several have mentioned: if you have brittle copper on the surface,
what happens in the holes; probably a lot more and the strain is a heck of
lot greater in the holes. Suggest you test you copper plating per IPC-RB-276
par. 3..5..8.3 which specifies test method IPC-TM-650 Method 2.4.18. Brittle
is inherent when there is either organic and/or metallic contamination of the
plating solution and it does not take very much, a few parts per billion of
certain compounds or elements will make the ductility go south.
Usual treatment is a peroxide/carbon treatment or dummying at a low current
density to remove unwanted metals, or send a sample to you chemical supplier
for a better analysis. You might pull of a conductor of of a board and
crease with the plating out and see what it does. Some people use a bend
test in place of the tensile/elongation test, but the number of bends before
breaking must be quantified with clad copper thickness, overplate thickness
and other conditions. Suggest yoou attack contamination in the copper bath .
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|