Manon Dutil wrote:
>
> snip <
>
> Solder balls that do not violate minimum electrical clearance.
>
        This begs an interesting question.

        Until all disciplines are referencing a common database
        where all rules are described, how should/could/would
        design be documenting spacings such as high voltage or
        special isolation areas to the downstream folks?

        Note that we are quite used to outlining areas where we
        can't allow thieving etc but the solder ball issue seems
        to bring a need for assembly notes as well...

        (leading question for the day)
--

      Jeff Seeger                         Applied CAD Knowledge Inc
      Chief Technical Officer                  Tyngsboro, MA  01879
      jseeger "at" appliedcad "dot" com                978 649 9800

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################