IPC-RB-276 has test procedure which was written around the bed-of-nails
bare-board testers.

The test requirement is basically as follows 
   1. Test continuity and shorts using IPC-ET-652 with the folowing
parameters:
       A.   Resistance of any circuit shall not exceed 50 ohms for Class 1,
or 20 ohms for              class 2 and 3.  For lengthy circuits specify what
you need.
       B.   Isolation resistance shall be greater than 0.5 megohm for class 1
and 2.0               megohms for class 3.  Voltage is selected is sufficient
to provide resolution,               but if not specified, it is 40 volts.

Presently I have received information that these parameters could not be used
for flying probe testers.  If this is so, I would like some advice on what it
should say so that the flying probe could be used per this specification
could be used.

Thanks 
Phil Hinton 
[log in to unmask] 
520-745-1013

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************