If it is on pins 1-5 you can drill a hole from the bottom, and punch it out.
Otherwise I would drill the whole pin out (oversized) and replace with a
stepped pin. Remember if the location changes a little you can change the
offset you that location in the proper.
Good luck
Mike Cox
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################