Subject: | |
From: | |
Date: | Wed, 24 Jan 96 08:47:00 CST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Subject: Re: Repair of PCBs
Bill,
You will find a section on Substrate Repair under IPC-R-700
Section IV procedure 4.1.1.4
I have done repairs of this sort based on this method.
After The Epoxy touch-up Material is baked with fiberglass
tape around it. We would remove the tape and take a file
and file the cured epoxy touch-up flush with the board to make it
dimensionally correct.
Good Luck
Nancy Nelson
DELL Computer Corp.
______________________________ Reply Separator _________________________________
Subject: Repair of PCBs
Author: [log in to unmask] at Dell_UNIX
Date: 1/23/96 1:53 PM
I have an infrequent situation where a PCB is dropped and the corner is
damaged. Is there a defined process or any training available on conducting
these types of repairs? I would rather not contract out the repair work.
Bill Barthel
Electronic Assembly Corp.
[log in to unmask]
(414) 751-3651
|
|
|