Bill Kasprzak said:

>We are currently working a job that uses NASA spec NHB5300.4(3A-2) as a
>guide for Requirements for Soldered Electrical Connections.
>Does anyone have any tricks for supporting the body of CK06 style leaded
>components which are mounted radially that needs to be supported approx.
>.060" up off the board ???  The "S" level component is not available with
>the "V" standoff on the body.


There are little glass beads made for this purpose.

You put the tiny devils on the leads, then install in the holes. I think
one source is:

Bivar, Inc.,
4 Thomas, Irvine, CA, 92718, USA
TEL: 714-951-8808; FAX: 714-951-3974


good luck,


Jerry Cupples
Interphase Corporation
Dallas, TX USA
http://www.iphase.com


***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************