Hi All,
Aren't there per job microsection requirements in 6012 ?  If so, I'd call
that an adder.

Regards,
Mark Hargreaves

        -----Original Message-----
        From:   Steve Gregory [SMTP:[log in to unmask]]
        Sent:   Monday, September 15, 2003 11:11 AM
        To:     [log in to unmask]
        Subject:        [TN] Building Fabs to IPC-6012 spec's...

        Hi All!

        Just a general question; how much of a cost adder would be incurred
building
        Class-2 fabs that comply with all the IPC-6012 specifications?

        Thanks!

        -Steve Gregory-


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------