My understanding is that the minimum soldermask thickness per IPC A-600E
2.9.10 Class 2 spec is 0.0004" minimum.
My question is whether this criteria applies everywhere on the circuit
board. Does it apply at the "knee" of the circuit?
If this is the criteria in IPC A-600E, why isn't the same criteria
documented in IPC-6012?
Kelly Kovalovsky
Phone 607-757-4595, FAX 607-757-4621
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################