Subject: | |
From: | |
Reply To: | |
Date: | Mon, 9 May 2011 15:04:07 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Many thanks.
________________________________
From: Larry Dzaugis [mailto:[log in to unmask]]
Sent: Monday, May 09, 2011 2:44 PM
To: TechNet E-Mail Forum; Joyce Koo
Subject: Re: [TN] Selective soldering with low residue flux?
VPS using preforms is dependant on PCB thickness.
As usual with pin in paste or preforms the thinner the PCB the easier.
The ramp rate on heating can be very high for a few seconds.
Selective solder will work with a 2-4% solids flux. I use both alcohol and water based.
Alcohol is preferred becasue of the type and amount of pre heating available.
Typicaly only IR is availale, convection has shown up on some new machines.
It works for both mass dip and point to point soldering.
---------------------------------------------------------------------
This transmission (including any attachments) may contain confidential information, privileged material (including material protected by the solicitor-client or other applicable privileges), or constitute non-public information. Any use of this information by anyone other than the intended recipient is prohibited. If you have received this transmission in error, please immediately reply to the sender and delete this information from your system. Use, dissemination, distribution, or reproduction of this transmission by unintended recipients is not authorized and may be unlawful.
______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 16.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
For additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|