A board (2 sided SMT w/4 TH connectors on top side) I am reviewing for
possible build contains connectors with bodies constructed of Nylon 6/6.
Per my McMaster-Carr "reference book", max temp for this material is
rated at 170F, with max intermittent temp rating of 355F.  My best guess
at this time is the connectors would deform/meltdown during reflow, and
would need to be hand added.  The connectors are Molex 52024 series.

Question; am I right?  Or has anyone successfully reflowed a connector
using this material.

Thanks in advance.

Eldon Sanders
Senior Manufacturing Engineer
Instromedix, Inc
[log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################