Subject: | |
From: | |
Date: | Thu, 25 Jul 96 14:00:53 EST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Is it possible for MEK to remove solder mask residues? Someone
recently told me this is so, but I'm not so sure.
MB
______________________________ Reply Separator _________________________________
Subject: FAB: Use of MEK
Author: [log in to unmask] at SMTPLINK-HADCO
Date: 7/19/96 08:08 PM
Address,
A majority of PCB shops out there use MEK (Methyl Ethyl Kentone)
in-house. To what extent are most of you using it? Are any of
you using MEK to clean rollers on the Resist Laminator or similar?
Other than being a health hazard and I'm aware the MEK attacks the
rollers. What else?
Please advise.
John Gulley
[log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|