Subject: | |
From: | |
Reply To: | |
Date: | Thu, 27 Jan 2005 14:29:09 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Scott
Not sure about screws, but how about rivets? Avdel (and likely others)
make auto feed rivets guns, and some rivets can be un-screwed for
disassembly if required.
Note - no commercial connection exists between me and Avdel, so this
isn't a commercial.
regards,
Graham Collins
Process Engineer,
L-3 Communications Electronic Systems Inc.
Halifax
(902) 873-2000 ext 6215
>>> [log in to unmask] 01/27/05 12:41PM >>>
I wanted to know if someone could point me in the right direction. I
am looking for some contacts for stock feed screw guns. I am looking
for the type that you feed a strip of screws into a gun and they snap
off after installation. If there is a tool that will except bulk
material, that would fit my need as well. I need this tool to install
.042 sheet metal during chassis assembly enclosures.
Thank you in advance!
Scott
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|