Victor,

I didn't realize the Dynaloy had been dissolved into Eastman!  Thanks!  I
learned something today.

Check out http://www.dynaloy.com/products-by-name.html for the data sheet.
Doesn't appear as though it needs to be heated.

My experience with the Dynaloy products is that time and temp are critical.
Once you find the sweet spot, you can remove all manner of materials, but do
have a really good hood!  Most of the stuff reeks worse than a dead skunk
that has been laying by the roadside for days in the hot sun.

I note that the Dynasolve 100 is only good for removing polymers, so it will
take the parts marking info off the chip resistor, but in the olden days we
used to use a low temp glass frit to passivate the surface of the resistor.
Don't believe that the Dynalloy 100 will be of much help there.




Steve Creswick
Sr Associate - Balanced Enterprise Solutions
http://www.linkedin.com/in/stevencreswick
                         616 834 1883

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez
Sent: Friday, May 10, 2013 3:13 PM
To: [log in to unmask]
Subject: [TN] DYNASOLVE 100

Fellow TechNetters:

   It's been a very long time since I last tried to remove the coating from
a ceramic film resistor.  I am using the above product but unable to
remember the temperature setting.

Victor,

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________