 
| Subject: | |
| From: | |
| Reply To: | TechNet E-Mail Forum. |
| Date: | Mon, 23 Jul 2001 16:01:37 +0100 |
| Content-Type: | text/plain |
| Parts/Attachments: |
|
|
Question?
There is a formula somewhere which I can use to calculate the maximum
allowable mass of a component in relation to the pad lands. Basically I
want to make sure our designers do not put components on the underside
of the PCB which are going to fall off during doublesided reflow.
I would like to point out that this is a design for manufacturability
question, not an attack on the tentative grasp on reality some card
designers have.
Steve.
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|
