Hello technet!
I got some capacitors that I feel like rejecting but before
I do, I need some experienced guru to confirm.
I have a chip component that is the same size as the pads.
I have no end Overhang but neither do I have a good solder
fillet, the ends of the part is almost flush with the ends
of the pads (not to says that in fact it is). I have a
tinny side fillet (but very tinny) or joint... So Accept
or Reject (The QA in me cant resist to reject!)
Anyone can help??
JF
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################