Hello again...

Looking for suggestions for removing masking material (tape or liquid) which
is applied to mask areas from conformal coating.  The way we do it now, the
operator masks off the area (usually tape), sprays the board, cures the
coating, scores the coating around the tape, then removes the tape.  We're
trying to eliminate the scoring of the coating since this has potential of
cutting through traces.  Removal of the coating prior to curing doesn't work
because the coating runs during the heat cure process.  I'm trying to avoid
room temperature cure since this is very time consuming.  Ant suggestions?

Jim Marsico
Senior Engineer
Production Engineering
EDO Electronics Systems Group
[log in to unmask] <mailto:[log in to unmask]>
631-595-5879

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------