Robert,
Its depend on the allowances of the PCB shop tolerance's (drill, V Cut
etc.) stress considerations and safety.
My recommendation is 32 mils minimum for traces.
Best Regards
Reuven
Robert Coburn
<Robert_Coburn@TD To: [log in to unmask]
IPOWER.COM> cc:
Sent by: TechNet Subject: [TN] Board edge to circuit spacing / IPC-2221 ?
<[log in to unmask]>
09/09/2003 17:20
Please respond to
"TechNet E-Mail
Forum."; Please
respond to
Robert_Coburn
Hi TechNetters;
The Design group I manufacture boards for has asked me if I know what the
minimum spacing requirements are from board edge to circuit.
I have looked through IPC-2221 and can't seem to identify anything.
Can anyone steer me in the right direction?
Thanks all; ---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
-----------------------------------------------------
Rob
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------