In twenty words or less describe the situation.
Is this Pin press fit into a large plate, machine table etc.
There may be an easy ans.
Fred Golisano
______________________________ Reply Separator _________________________________
Subject: [TN] Dowel repair for Fuji CP3 D-table
Author: "TechNet E-Mail Forum." <[log in to unmask]>, at corp
Date: 4/16/98 12:46 PM
Do anyone of you have a good suggestion how to take a
half-broken dowel (round pin) out from D-table of Fuji CP3? The
pin is too tough to be drilled out. Appreciate your
response before I decide to take a drastic action.
mpark
NII Norsat International Inc.
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text
in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################