Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 27 Jun 2000 19:08:15 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
In a message dated 06/27/2000 6:00:12 PM Central Daylight Time,
[log in to unmask] writes:
> Hi Steve, I believe Universal published a guide for axial and radial
> insertion using their machines back in the 1970's and 80's... I had to use
> it to do my boards from back then... Do you have access to that
> documentation? If not, I will look for it in my archives at home...
> - Bill Brooks
>
>
> Bill Brooks
> Senior PCB Designer - [log in to unmask] <mailto:[log in to unmask]>
>
> Zoneworx, Inc.
> 40925 County Center Drive, STE 200
> Temecula, CA 92591
> http://www.zoneworx.com <http://www.zoneworx.com>
> Tel: (909) 296-1226 x 1037
> Co-Director / Education Officer / Webmaster
> for the San Diego Chapter of the IPC Designers Council
> http://www.ipc.org/SanDiego/index.html
> <http://www.ipc.org/SanDiego/index.html>
Hi Bill!
Yeah, I got that...it's on their web page in an Adobe Acrobat file. They say
you should have a .019" +/- .003" larger hole than the lead diameter. What I
was trying to learn is if anybody has tried to push those limits and what
success they've had. Just so I can put to rest the notion of trying to run
this board on the VCD...
Thanks!
-Steve Gregory-
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|