I am confused.

For years, I have understood that the best way to store pcb's prior to
assembly is in a heated, relatively dry environment.  I am sure that the
general consensus amongst most manufactureres is that this works best.

Well, just recently I was told by a company setting up a new facility that
they had been advised by a well known consultant to use a cold dry
environment.  They are planning a 12-14 degree Celsius storeroom, once
again relatively dry.

Is there new thinking on this, or have they been badly advised?




[Nicholas Kane]
[Axion Australasia]
[Suite 3, 651 Canterbury Road]
[Surrey Hills]
[Victoria 3127 Australia]
[tel: 613 9899 3511    fax: 613 9899 3811]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################