One other item that you should be aware of is that many of the USA PWB fabricators farm this operation out to a specialty fabricator who basically does only this type of work.

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of David Bealer
Sent: Tuesday, April 23, 2013 6:17 AM
To: [log in to unmask]
Subject: [TN] Via in pad using filled or plugged vias

We are looking at the possibility of using boards designed with vias in pad and having those vias filled.  What should we be concerned with? ( I know this is a overly broad question, just looking for a place to start.)

Thanks,

David Bealer
SMT Department Manager
office 800-637-2645 x6022   cell 217-474-8760
email [log in to unmask]<mailto:[log in to unmask]>

Watchfire Headquarters  *  watchfiresigns.com<http://www.watchfiresigns.com/>
sales 800-637-2645   service 866-637-2645


______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
________________________________
 This message and any attachments are solely for the use of the addressee and may contain L-3 proprietary information that may also be defined as USG export controlled technical data. If you are not the intended recipient, any disclosure, use or distribution of its content is prohibited. Please notify the sender by reply e-mail and immediately delete this message and any attachments.

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________