Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 2 Nov 1998 07:37:41 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
hi Tim,
try baking the part and modifying the reflow profile, i.e longer pre-heat at
lower temp...that may help considerably
Marcelo
-----Original Message-----
From: Stammely, Tim [SMTP:[log in to unmask]]
Sent: Saturday, October 31, 1998 7:29 AM
To: [log in to unmask]
Subject: [TN] BGA rework question
Hello all,
We are trying to remove and replace two ORCA 432 pin BGA's on a big
14-layer
board. We are getting alot of shorts after the rework(I'm x-ray
inspecting).
At first we tried solder pasting the pads with a mini stencil, but the
amount of bridging we got caused me to try just fluxing the pads and
letting
the solder balls collapse, but we still got a lot of shorts. I am also
noticing a lot of board warpage during the rework heat cycle and it
also
appears that during reflow if I watch the component, the corners of the
BGA
collapse very early and the component almost appears to be bowing. Most
of
the shorts we are getting are in the corners where this last observation
occurs making me think it is causing the shorts. Any suggestions on how
to
eliminate this problem?
Thanks,
Tim Stammely
Manufacturing/Process Engineer
MSI
Manassas, VA
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV
1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|