Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Sat, 26 Sep 1998 13:01:52 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Stuart,
That all depends on how well equipped your fab house is. Some
facilities are equipped with machinery that can accommodate hundreds
of sizes in their tool magazines and controller software. Some shops
use machinery that can handle 9 or less tools at a time. If I
remember correctly from design 101, the specs for typical leaded
components have quite a wide range for finished hole diameter that
assembly operations can accommodate. If keeping your tool quantities
down has to be a consideration, you can try to take advantage of these
ranges when you set up your hole/pad stacks in the CAD library. (Or
just eliminate leaded components, ha!)
Mike Mikucki
______________________________ Reply Separator _________________________________
Subject: [TN] Increase number of drill sizes
Author: Stuart Chessen <[log in to unmask]> at
SMTPLink-Hadco
Date: 9/26/98 6:51 AM
Over the past year we have upgraded our CAD library. Each component
has it own pad and/or hole size in the library. I have noticed this
has doubled the number of different drills needed compared with
previous boards layout in years past . Some of the drills sizes only
vary by .003".
What problems is this causing for the board fab house?
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text
in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for
additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700
ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|