I'm in search of a little insight, if you will.  I'm witnessing random solder
skips on the bottomside of my panels.  Everything is clean, but I've switched
mask types from the glossy to the matte finish.  Why would that cause random
solder skips on the small chips and resistors on the bottomside 805's and 603's?
I'm trying to put some technical reasoning behind just witnessing the problem.

Jason Smith

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################