Hello
Does anyone have experience trying to control the height of an LCC
(leadless) off the board. I have drawing requirements of .008".
The components are ceramic and are on both sides of the board.
The board is mixed technology and extremely dense. It also has a
.062" heatsink (plate) on the top side. Top side printing is out of
the question.
The volumes are low (about 80)
LCC component count is about 30 per board
The design is fixed (no chance in He** of changing
Spec 's are Military ie..2000
I have tried to locate water/solvent soluable waffers with no luck (.008")
Hand soldering with a spacer is not my preffered option either
Any recomendations would be appriciated
Thanks in advance
Wesley Samples
[log in to unmask]
(817) 234-6842
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************